Purpose Made Cavity Trays

• One-piece seamless mouldings eliminate the need for site fabrication to prevent errors through poor workmanship
• Tailor-made to order – manufactured to suit exact customer requirements with delivery to site usually within 10-14 working days
• Easy to handle, flexible, tough, durable and puncture resistant
• Fully compatible with all Timloc DPC and cavity tray systems
• Can be used for multi-storey or high loading applications – will not extrude under loads up to the point of compressive failure of wall
• Wide range of standard components with special, tailor-made accessories also readily available

• Manufactured to BS EN ISO 9001 and BS EN ISO 14001
• Design principals comply with all relevant Building Regulations and relevant British Standards

• Vacuum formed in 2mm medium density polyethylene.
• In line heat bending in 2mm polypropylene.
• Available in Black only.

F30 Accessories/sundry items for brick/block/stone walling

Clause 385 | PREFORMED DPC / CAVITY TRAY JUNCTION CLOAKS / STOPENDS

• Manufacturer: Timloc Building Products, Timloc House, Ozone Park, Howden, East Yorkshire, DN14 7SD. T: 01405 765567 W: www.timloc.co.uk
• Type(s) and location(s): Preformed made to measure Cavity tray to be designed to fit around non standard bespoke applications, such as columns, wind posts, corners, lintels etc
• Seal all laps with dpc and/or cavity trays using adhesive or mastic in accordance with manufacturers recommendations to ensure a fully watertight installation.
• Reference: Timloc Purpose Made Cavity Trays
• Types shown on drawings

• As with all DPC systems, purpose made units should always be bedded on to fresh mortar, never dry bedded. The masonry laid over the DPC and purpose made unit should also be bedded on to fresh mortar so that the DPC system is approximately halfway through the thickness of the mortar joint.
• Continuation of DPC must be lapped on to the purpose made unit by a minimum of 100mm.
• All lapped joints must be fully sealed with jointing tape (not all units are supplied with jointing tape attached). It is essential that the jointing surfaces are clean and dry or the jointing surfaces will not seal correctly.
• All DPC items should be installed to relevant codes of practice.

• Cavity trays are made to order, so please supply full construction details. Ideally these will include a fully dimensioned drawing.

• Cavity trays for brick support systems
• Pier, column, and corner cloaks
• Threshold trays
• Change of level units
• Stop end and junction capping
• Radius units
• Ring beam cavity tray systems
• Parapet cavity tray systems